Scott, get in touch with Midwest Gunworks

by brionic , Sunday, August 30, 2015, 10:09 (3313 days ago) @ Scott Ambler

if not to hire them, to solicit their advice on a suitable gunsmith

They are the Browning factory repair shop for obsolete firearms, or at least they used to be. I understand they do good work, although their rate card seems a bit pricey, especially in light of two way shipping.

Neat gun, for sure, that begs for optimizing.
--
Brian

Post reply

544 views

Complete thread:

RSS Feed of thread

Bullets for Browning 53, 32-20 - Scott Ambler, 2015-08-29, 10:41
- WHOA! That seems to be a VERY short throat. - Hobie, 2015-08-29, 11:32
  - WHOA! That seems to be a VERY short throat. - Scott Ambler, 2015-08-29, 11:54
    - browning made a lot of the 53s, and the 45/70s - cable, 2015-08-29, 12:21
- Bullets for Browning 53, 32-20 - Cherokee, 2015-08-29, 18:48
  - Bullets for Browning 53, 32-20 - Scott Ambler, 2015-08-29, 20:53
    - it's easy and would be hard to mess it up - cable, 2015-08-29, 21:26
      - it's easy and would be hard to mess it up - Scott Ambler, 2015-08-29, 22:33
        
        i would buy or rent a throating reamer and do it myself. i - cable, 2015-08-29, 22:48
        
        Cable...... - Scott Ambler, 2015-08-30, 09:20
        
        Scott, get in touch with Midwest Gunworks - brionic, 2015-08-30, 10:09
        
        Doc, I have seen Scott load magazines... He needs an - Rob Leahy, 2015-08-30, 15:19
        
        oh............... well as you know i am almost that bad too - cable, 2015-08-30, 17:42
        
        32-20 and Short throat - Todd C, 2015-09-13, 17:56

The Frontier Sixshooter Community Message Board

Scott, get in touch with Midwest Gunworks