Sounds like you're in business, Doug.
Only thing left is learning to set the bullet punch to position the bullet grooves even with the die holes before the lube shot. Trial and error at first, but measure it and write it down and it goes quick the next time.
Complete thread:
- Star luber/sizer -
Slow Hand,
2019-01-27, 18:34
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Star luber/sizer -
Mark,
2019-01-28, 05:55
- Star luber/sizer -
Cherokee,
2019-01-28, 07:03
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:38
- Star luber/sizer - Mark, 2019-01-29, 05:53
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:38
- Star luber/sizer -
Cherokee,
2019-01-28, 07:03
- Star luber/sizer - uncowboy, 2019-01-28, 07:07
- Star luber/sizer -
John K.,
2019-01-28, 07:58
- Ballisticast sizer. -
MS,
2019-01-28, 12:14
- No need for a PID controller. -
John K.,
2019-01-28, 17:35
- Thanks John, I would appreciate that - MS, 2019-01-29, 08:49
- No need for a PID controller. -
John K.,
2019-01-28, 17:35
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:44
- Sounds like you're in business, Doug. -
John K.,
2019-01-28, 17:59
- Sounds like you're in business, Doug. - Slow Hand, 2019-01-28, 18:10
- Sounds like you're in business, Doug. -
John K.,
2019-01-28, 17:59
- Ballisticast sizer. -
MS,
2019-01-28, 12:14
- Star luber/sizer Dies-email -
Cherokee,
2019-01-28, 21:09
- Star luber/sizer Dies-email - Slow Hand, 2019-01-29, 04:13
- Star luber/sizer -
Creeker,
2019-01-30, 13:55
- Lynn, do you pre-load those tubes off the machine? -
John K.,
2019-01-31, 20:06
- Lynn, do you pre-load those tubes off the machine? -
Creeker,
2019-01-31, 20:24
- Good method. - John K., 2019-01-31, 20:46
- Lynn, do you pre-load those tubes off the machine? -
Creeker,
2019-01-31, 20:24
- Star luber/sizer -
Slow Hand,
2019-02-01, 17:47
- Star luber/sizer - Creeker, 2019-02-01, 18:06
- Lynn, do you pre-load those tubes off the machine? -
John K.,
2019-01-31, 20:06
- Star luber/sizer -
Mark,
2019-01-28, 05:55