No need for a PID controller.
In fact, I used the same on my ballisticast.
It was a 110Vac pad heater for an embossing machine for marking condom cartons. When we switched from embossing to inkjets, there were quite a few of the heaters to be discarded. Think I gave one to Farmer Ed. If you still have the aluminum plate, all you need is the heater; I'm pretty sure I still have some left - will send you one.
Complete thread:
- Star luber/sizer -
Slow Hand,
2019-01-27, 18:34
- Star luber/sizer -
Mark,
2019-01-28, 05:55
- Star luber/sizer -
Cherokee,
2019-01-28, 07:03
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:38
- Star luber/sizer - Mark, 2019-01-29, 05:53
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:38
- Star luber/sizer -
Cherokee,
2019-01-28, 07:03
- Star luber/sizer - uncowboy, 2019-01-28, 07:07
- Star luber/sizer -
John K.,
2019-01-28, 07:58
- Ballisticast sizer. -
MS,
2019-01-28, 12:14
- No need for a PID controller. -
John K.,
2019-01-28, 17:35
- Thanks John, I would appreciate that - MS, 2019-01-29, 08:49
- No need for a PID controller. -
John K.,
2019-01-28, 17:35
- Star luber/sizer -
Slow Hand,
2019-01-28, 17:44
- Sounds like you're in business, Doug. -
John K.,
2019-01-28, 17:59
- Sounds like you're in business, Doug. - Slow Hand, 2019-01-28, 18:10
- Sounds like you're in business, Doug. -
John K.,
2019-01-28, 17:59
- Ballisticast sizer. -
MS,
2019-01-28, 12:14
- Star luber/sizer Dies-email -
Cherokee,
2019-01-28, 21:09
- Star luber/sizer Dies-email - Slow Hand, 2019-01-29, 04:13
- Star luber/sizer -
Creeker,
2019-01-30, 13:55
- Lynn, do you pre-load those tubes off the machine? -
John K.,
2019-01-31, 20:06
- Lynn, do you pre-load those tubes off the machine? -
Creeker,
2019-01-31, 20:24
- Good method. - John K., 2019-01-31, 20:46
- Lynn, do you pre-load those tubes off the machine? -
Creeker,
2019-01-31, 20:24
- Star luber/sizer -
Slow Hand,
2019-02-01, 17:47
- Star luber/sizer - Creeker, 2019-02-01, 18:06
- Lynn, do you pre-load those tubes off the machine? -
John K.,
2019-01-31, 20:06
- Star luber/sizer -
Mark,
2019-01-28, 05:55