Dillon 550 question...
If it is dragging as you do up and down make sure the set screw for the tool head is screwed all the way in.
IF it is dragging as you turn the too head make sure one of those little aluminum arms is not bent down and dragging on the loaded round ejection wire.
A good wash down with solvent and oiling the moving points is probably a good thing to do every once in a while, but I have not done so.
Complete thread:
- Dillon 550 question... -
Bryan,
2016-12-31, 22:15
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- I keep degreasing and flushing with light oil... - Bryan, 2016-12-31, 22:32
- Yes I have..... -
Gunner,
2016-12-31, 22:32
- I was looking for a video how to. Haven't found it yet. NT -
Bryan,
2016-12-31, 22:33
- Dillon reloading group on FB NT - Rob Leahy, 2017-01-01, 07:07
- I was looking for a video how to. Haven't found it yet. NT -
Bryan,
2016-12-31, 22:33
- Dillon 550 question... -
RidinLou,
2016-12-31, 23:10
- Right...all that is in good order... -
Bryan,
2016-12-31, 23:17
- Got it! Cleaning everything now. Has to help. NT - Bryan, 2016-12-31, 23:31
- Right...all that is in good order... -
Bryan,
2016-12-31, 23:17
- the free rebuild is a good bet.nt - Rob Leahy, 2017-01-01, 07:24
- Dillon 550 question... -
John K.,
2017-01-01, 08:23
- Dillon 550 question... -
uncowboy,
2017-01-01, 09:28
- Got it going again. Thanks all. Used 3 in 1 oil. NT -
Bryan,
2017-01-01, 09:42
- Got it going again. Thanks all. Used 3 in 1 oil. NT -
RidinLou,
2017-01-01, 10:50
- WD40 does that - Slow Hand, 2017-01-01, 20:35
- Got it going again. Thanks all. Used 3 in 1 oil. NT -
RidinLou,
2017-01-01, 10:50
- Got it going again. Thanks all. Used 3 in 1 oil. NT -
Bryan,
2017-01-01, 09:42
- If you remove the plate on top of the ram - anachronism, 2017-01-02, 11:11
- Dillon 550 question... -
uncowboy,
2017-01-01, 09:28