One area well worth spending some extra $$ on...

by mcassill, Tuesday, April 14, 2015, 14:30 (3515 days ago) @ rob

Get the NP3-coated bolt carrier group. Some vendors will call it "nickel boron". A lot slicker than the mil spec parkerized, and a lot easier to wipe crud off of. The same MAY be true of a nitrided BCG, but I have not tried one.

Post reply

487 views

Complete thread:

RSS Feed of thread

AR Lower receiver parts question... - rob, 2015-04-13, 14:27
- CMMG makes good parts kits and they give great support - Rob Leahy, 2015-04-13, 14:37
  - Mil-spec seems to be most common so... - rob, 2015-04-13, 16:31
- You small parts will do fine - Miles, 2015-04-13, 23:06
  - You small parts will do fine - rob, 2015-04-13, 23:12
- If I may... - Byron, 2015-04-14, 10:08
  - If I may... - rob, 2015-04-14, 11:37
- One area well worth spending some extra $$ on... - mcassill, 2015-04-14, 14:30
  - definitely on the list.... - rob, 2015-04-14, 14:43
    - A fellow can never have too many good rifles :-) - mcassill, 2015-04-14, 17:31
      - A fellow can never have too many good rifles :-) - rob, 2015-04-14, 17:38
      - Let's hope the bill passes - brionic, 2015-04-14, 17:52
        
        I have three lathes and a two mills in my garage - mcassill, 2015-04-14, 17:54
        
        I have three lathes and a two mills in my garage - Slow Hand, 2015-04-14, 20:21
        
        SBRs aren't even on the table here just yet - mcassill, 2015-04-14, 20:33
        
        SBRs aren't even on the table here just yet - Slow Hand, 2015-04-15, 05:23
        
        I already have :-) - mcassill, 2015-04-15, 06:34
      - A fellow can never have too many good rifles :-) - Hoot, 2015-04-15, 08:18

The Frontier Sixshooter Community Message Board

One area well worth spending some extra $$ on...