If I may...

by rob , Tuesday, April 14, 2015, 11:37 (3515 days ago) @ Byron

I will likely buy an upper from Spikes to match my lower. I know it isn't a matched set but the finish should be a good match and they ought to go well enough together. For a fighting/misc varmint rifle it's good enough for me. If I'm gonna did deep on a rifle it will be a top grade bolt gun or a vintage 1886 Winchester.

Post reply

480 views

Complete thread:

RSS Feed of thread

AR Lower receiver parts question... - rob, 2015-04-13, 14:27
- CMMG makes good parts kits and they give great support - Rob Leahy, 2015-04-13, 14:37
  - Mil-spec seems to be most common so... - rob, 2015-04-13, 16:31
- You small parts will do fine - Miles, 2015-04-13, 23:06
  - You small parts will do fine - rob, 2015-04-13, 23:12
- If I may... - Byron, 2015-04-14, 10:08
  - If I may... - rob, 2015-04-14, 11:37
- One area well worth spending some extra $$ on... - mcassill, 2015-04-14, 14:30
  - definitely on the list.... - rob, 2015-04-14, 14:43
    - A fellow can never have too many good rifles :-) - mcassill, 2015-04-14, 17:31
      - A fellow can never have too many good rifles :-) - rob, 2015-04-14, 17:38
      - Let's hope the bill passes - brionic, 2015-04-14, 17:52
        
        I have three lathes and a two mills in my garage - mcassill, 2015-04-14, 17:54
        
        I have three lathes and a two mills in my garage - Slow Hand, 2015-04-14, 20:21
        
        SBRs aren't even on the table here just yet - mcassill, 2015-04-14, 20:33
        
        SBRs aren't even on the table here just yet - Slow Hand, 2015-04-15, 05:23
        
        I already have :-) - mcassill, 2015-04-15, 06:34
      - A fellow can never have too many good rifles :-) - Hoot, 2015-04-15, 08:18

The Frontier Sixshooter Community Message Board

If I may...