If I may...

by Byron, Tuesday, April 14, 2015, 10:08 (3515 days ago) @ rob

If you plan is to ultimately put together a really top shelf AR15 perhaps you should consider to get a matched set of upper and lower.

While the finished product would not be any more reliable or accurate if you used separate upper and lower parts it would be more stuffy and "zoot capri", if you know what I mean.

This set would make a really nice rifle. There are many other outfits putting out similar sets.

http://wilsoncombat.com/new/billet-ar.asp#.VS0sWtzF-So

Something to think about.

Byron

Post reply

508 views

Complete thread:

RSS Feed of thread

AR Lower receiver parts question... - rob, 2015-04-13, 14:27
- CMMG makes good parts kits and they give great support - Rob Leahy, 2015-04-13, 14:37
  - Mil-spec seems to be most common so... - rob, 2015-04-13, 16:31
- You small parts will do fine - Miles, 2015-04-13, 23:06
  - You small parts will do fine - rob, 2015-04-13, 23:12
- If I may... - Byron, 2015-04-14, 10:08
  - If I may... - rob, 2015-04-14, 11:37
- One area well worth spending some extra $$ on... - mcassill, 2015-04-14, 14:30
  - definitely on the list.... - rob, 2015-04-14, 14:43
    - A fellow can never have too many good rifles :-) - mcassill, 2015-04-14, 17:31
      - A fellow can never have too many good rifles :-) - rob, 2015-04-14, 17:38
      - Let's hope the bill passes - brionic, 2015-04-14, 17:52
        
        I have three lathes and a two mills in my garage - mcassill, 2015-04-14, 17:54
        
        I have three lathes and a two mills in my garage - Slow Hand, 2015-04-14, 20:21
        
        SBRs aren't even on the table here just yet - mcassill, 2015-04-14, 20:33
        
        SBRs aren't even on the table here just yet - Slow Hand, 2015-04-15, 05:23
        
        I already have :-) - mcassill, 2015-04-15, 06:34
      - A fellow can never have too many good rifles :-) - Hoot, 2015-04-15, 08:18

The Frontier Sixshooter Community Message Board

If I may...