that's how I thought it was supposed to work...
by rob 
, Tuesday, September 30, 2014, 20:53 (3712 days ago) @ Jared
This Hornady is larger than a small pistol primer and smaller than a large...I'd guess about halfway between the two without measuring. If you even try to just ream the crimp it leaves a nasty square step. It says it's for removing the crimp but I would take issue with that:/
Complete thread:
- How is a Hornady primer pocket reamer supposed to work? -
rob,
2014-09-30, 19:11
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- How is a Hornady primer pocket reamer supposed to work? -
Jared,
2014-09-30, 20:49
- that's how I thought it was supposed to work... -
rob,
2014-09-30, 20:53
- without some kid of positive stop it sounds pretty useless. -
Jared,
2014-09-30, 21:10
- I think it's just too big... - rob, 2014-09-30, 22:06
- without some kid of positive stop it sounds pretty useless. -
Jared,
2014-09-30, 21:10
- that's how I thought it was supposed to work... -
rob,
2014-09-30, 20:53
- How is a Hornady primer pocket reamer supposed to work? -
Hobie,
2014-09-30, 22:43
- I added the RCBS swaging dies to my Midway... -
rob,
2014-09-30, 22:49
- I added the RCBS swaging dies to my Midway... - Cherokee, 2014-10-01, 07:41
- I added the RCBS swaging dies to my Midway... - Jared, 2014-10-01, 22:28
- I added the RCBS swaging dies to my Midway... -
rob,
2014-09-30, 22:49
- Back when Ford was president -
John K.,
2014-10-01, 14:09
- My first job, for no pay, was in a small reloading/gun shop. -
Rob Leahy,
2014-10-01, 15:07
- Properly set up the RCBS unit is quicker than the - Hobie, 2014-10-01, 15:45
- My first job, for no pay, was in a small reloading/gun shop. -
Rob Leahy,
2014-10-01, 15:07
- How is a Hornady primer pocket reamer supposed to work? -
Paul,
2014-10-01, 16:46
- yep, except its threaded on the end with no handle... - rob, 2014-10-01, 18:30
- How is a Hornady primer pocket reamer supposed to work? -
Jared,
2014-09-30, 20:49