How is a Hornady primer pocket reamer supposed to work?

by Jared, Tuesday, September 30, 2014, 20:49 (3712 days ago) @ rob

I am not sure about the hornady, but I have a RCBS military crimp remover on my Trim Pro.

http://www.midwayusa.com/product/594559/rcbs-trim-mate-case-prep-center-military-crimp-...

You just press the case on it until it bottoms out and the crimp is gone. The case also has a nice chamfer for seating a new primer. It is the quickest way I have found to remove the crimp. Each case takes a couple of seconds.

Post reply

554 views

Complete thread:

RSS Feed of thread

How is a Hornady primer pocket reamer supposed to work? - rob, 2014-09-30, 19:11
- How is a Hornady primer pocket reamer supposed to work? - Jared, 2014-09-30, 20:49
  - that's how I thought it was supposed to work... - rob, 2014-09-30, 20:53
    - without some kid of positive stop it sounds pretty useless. - Jared, 2014-09-30, 21:10
      - I think it's just too big... - rob, 2014-09-30, 22:06
- How is a Hornady primer pocket reamer supposed to work? - Hobie, 2014-09-30, 22:43
  - I added the RCBS swaging dies to my Midway... - rob, 2014-09-30, 22:49
    - I added the RCBS swaging dies to my Midway... - Cherokee, 2014-10-01, 07:41
    - I added the RCBS swaging dies to my Midway... - Jared, 2014-10-01, 22:28
- Back when Ford was president - John K., 2014-10-01, 14:09
  - My first job, for no pay, was in a small reloading/gun shop. - Rob Leahy, 2014-10-01, 15:07
    - Properly set up the RCBS unit is quicker than the - Hobie, 2014-10-01, 15:45
- How is a Hornady primer pocket reamer supposed to work? - Paul, 2014-10-01, 16:46
  - yep, except its threaded on the end with no handle... - rob, 2014-10-01, 18:30

The Frontier Sixshooter Community Message Board

How is a Hornady primer pocket reamer supposed to work?