Bowling Pin Thump Question

by Slow Hand ⌂ @, Indiana, Sunday, June 02, 2013, 16:00 (4196 days ago) @ Charles

I haven't shot in a pin match in a few years. But I had good luck with a modified .45 acp hardball mold. It basically looked like someone ran an end mill into a 230 gr mold. It had a big, flat meplat and added about 15-20 gr of weight. It knocked the pins straight off of the table!

The guy who often won (when he beat me) used an 8" 629 loaded with Keith level .44 Special loads. He was a good shot and often went five for five, but is hits would drive the pins straight back off of the table. Good center hits with a heavy bullet are the key to knocking pins off the table versus chasing them down as try roll around I've seen guys empty multiple 17 round mags bouncing pins all over the table!!


Complete thread:

 RSS Feed of thread

powered by my little forum