Is there enough meat to thread, and would you need to

by Slow Hand , Indiana, Sunday, April 28, 2013, 16:32 (4230 days ago) @ John K.

It's thick enough. Front sight is on the barrel band but I have a new sight. My problem is my machinist can't fit the reciever in his lathe. I don't have the means to remove the barrel. I'll also have to shorten the mag tube a bit but I can handle that.

My can is a Thompson Machine Isis-9. It uses gemtech multimount rear mounts and I have a fixed barrel mount in 1/2"x28 and 5/8"x24 along with a booster and an Uzi barrel nut mount.

Post reply

729 views

Complete thread:

RSS Feed of thread

For the discriminating .44 Magnum shooter.... - Glen, 2013-04-27, 13:49
- For the discriminating .44 Magnum shooter.... - Slow Hand, 2013-04-27, 19:42
  - For the discriminating .44 Magnum shooter.... - bob, 2013-04-27, 20:38
    - No, that bullet was.... - Glen, 2013-04-27, 20:43
- For the discriminating .44 Magnum shooter.... - RidinLou, 2013-04-28, 12:59
  - I've only tried one load.... - Glen, 2013-04-28, 13:42
- That looks like it would be fun in a single shot with a can. - John K., 2013-04-28, 13:05
  - That looks like it would be fun in a single shot with a can. - Slow Hand, 2013-04-28, 13:57
    - Is there enough meat to thread, and would you need to - John K., 2013-04-28, 14:37
      - Is there enough meat to thread, and would you need to - Slow Hand, 2013-04-28, 16:32
        
        Doug, if your machinist has enough bed length, - John K., 2013-04-29, 20:56
        
        Doug, if your machinist has enough bed length, - Slow Hand, 2013-04-30, 04:07
- I'm going to post this elsewhere - Glen, 2013-04-28, 18:33
- For the discriminating .44 Magnum shooter.... - RidinLou, 2013-04-28, 19:41

The Frontier Sixshooter Community Message Board

Is there enough meat to thread, and would you need to