I have been looking at those.
#2 black N decker workmate. Mount your equipment to a 2x6 the length of the table . Mounts to the middle and you reload from the side It handles my lubbers case prep center single stage press turret press and foster case trimmers. Plug n play. Folds up when done. J.Michael
Complete thread:
- Looking for reloading bench ideas... -
Bryan,
2016-09-27, 20:02
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- you need interchangeable tops -
bj,
2016-09-27, 20:18
- you need interchangeable tops -
Creeker,
2016-09-27, 20:35
- Interesting. I wasn't aware of this company. Thx! NT -
Bryan,
2016-09-27, 21:07
- Interesting. I wasn't aware of this company. Thx! NT -
Creeker,
2016-09-27, 21:22
- Would be curious to see a photo of your setup? -
Bryan,
2016-09-27, 22:03
- I'll open a new thread on the desk - Creeker, 2016-09-28, 09:35
- Would be curious to see a photo of your setup? -
Bryan,
2016-09-27, 22:03
- Interesting. I wasn't aware of this company. Thx! NT -
Creeker,
2016-09-27, 21:22
- I have been looking at those. -
Hoot,
2016-09-28, 05:49
- I have been looking at those. - uncowboy, 2016-09-28, 09:04
- Interesting. I wasn't aware of this company. Thx! NT -
Bryan,
2016-09-27, 21:07
- you need interchangeable tops -
Creeker,
2016-09-27, 20:35
- Workmate - Brien1, 2016-09-27, 23:07
- Looking for reloading bench ideas... -
Robb Barnes,
2016-09-28, 00:38
- Your system sounds beautiful - Creeker, 2016-09-28, 09:29
- If you can't anchor it, add as much weight as you can. -
John K.,
2016-09-29, 13:51
- Good point. NT - Bryan, 2016-09-29, 15:19
- Looking for reloading bench ideas... - DiamondD, 2016-10-04, 20:13
- you need interchangeable tops -
bj,
2016-09-27, 20:18