Looking for reloading bench ideas...
I had large steel plates made for each of my presses and I C clamp the one I need to use down on my reloading table. a few extra threaded holes and I can clamp my RCBS priming tool right next to one of the presses as well. There are felt pads under each steel plate to protect the wood top of the table since I made it to be a furniture type table with hardwood maple top.
Complete thread:
- Looking for reloading bench ideas... -
Bryan,
2016-09-27, 20:02
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- you need interchangeable tops -
bj,
2016-09-27, 20:18
- you need interchangeable tops -
Creeker,
2016-09-27, 20:35
- Interesting. I wasn't aware of this company. Thx! NT -
Bryan,
2016-09-27, 21:07
- Interesting. I wasn't aware of this company. Thx! NT -
Creeker,
2016-09-27, 21:22
- Would be curious to see a photo of your setup? -
Bryan,
2016-09-27, 22:03
- I'll open a new thread on the desk - Creeker, 2016-09-28, 09:35
- Would be curious to see a photo of your setup? -
Bryan,
2016-09-27, 22:03
- Interesting. I wasn't aware of this company. Thx! NT -
Creeker,
2016-09-27, 21:22
- I have been looking at those. -
Hoot,
2016-09-28, 05:49
- I have been looking at those. - uncowboy, 2016-09-28, 09:04
- Interesting. I wasn't aware of this company. Thx! NT -
Bryan,
2016-09-27, 21:07
- you need interchangeable tops -
Creeker,
2016-09-27, 20:35
- Workmate - Brien1, 2016-09-27, 23:07
- Looking for reloading bench ideas... -
Robb Barnes,
2016-09-28, 00:38
- Your system sounds beautiful - Creeker, 2016-09-28, 09:29
- If you can't anchor it, add as much weight as you can. -
John K.,
2016-09-29, 13:51
- Good point. NT - Bryan, 2016-09-29, 15:19
- Looking for reloading bench ideas... - DiamondD, 2016-10-04, 20:13
- you need interchangeable tops -
bj,
2016-09-27, 20:18