Yup... this is the same problem I had...
by D. Sikes 
, Friday, August 01, 2014, 21:57 (3772 days ago) @ Charles
This is the same problem I had when I was trying to fix my Uberti made 1860... I finally got a pawl (Thanks for the correction Rob... GRIN)that was close and I took my grinder and file to it to make it fit... after you measure the pin hole in the hammer... get the closest fitting pawl that has a slightly oversize pin and then either reduce the pin or enlarge the hole in the hammer to fit...
The only other option would be to order a hammer and pawl "set" .. but then you might get into the problem with a "not quite right fit" hammer too... such is the problem with Italian made clones.. parts can change from year to year from the same manufacturer...
Good Luck... GRIN
Complete thread:
- More SAA help please -
Charles,
2014-07-29, 11:33
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- More SAA help please - Cherokee, 2014-07-29, 13:27
- More SAA help please -
visitor,
2014-07-29, 19:17
- I looked earlier today... -
cas,
2014-07-29, 19:41
- Wouldn't surprise me much -
Hoot,
2014-07-29, 21:25
- Alan Harton told me -
cubrock,
2014-07-29, 23:05
- Alan Harton told me -
Bob Hatfield,
2014-07-31, 16:29
- I've never understood how people…. - cas, 2014-07-31, 16:40
- Alan Harton told me -
Bob Hatfield,
2014-07-31, 16:29
- Alan Harton told me -
cubrock,
2014-07-29, 23:05
- Wouldn't surprise me much -
Hoot,
2014-07-29, 21:25
- I looked earlier today... -
cas,
2014-07-29, 19:41
- A little more - Charles, 2014-07-30, 07:53
- Yup... this is the same problem I had... -
D. Sikes,
2014-08-01, 21:57
- That is the best solution - Charles, 2014-08-07, 13:11