You may want to measure that barrel again
by Fivegunner 
, LOWELL Mi., Thursday, July 24, 2014, 16:21 (3780 days ago) @ cubrock
I measured again face of cylinder to end of barrel = 4 inches . the serial # are all the same, inside of ejector housing, back of cylinder ,butt of gun and the grips . this is realy a nice clean Smith that I bought about 5 years ago from a Ace Hardware store. I am going to buy a camera this weekend so I can post so pictures. 
Complete thread:
- S&W pre 27??? -
Fivegunner,
2014-07-23, 15:51
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- S&W pre 27??? - Wildcat, 2014-07-23, 17:49
- Approximately 1954 (NM). - Murphy, 2014-07-23, 18:09
- You may want to measure that barrel again -
cubrock,
2014-07-23, 20:52
- You may want to measure that barrel again -
Fivegunner,
2014-07-24, 16:21
- You either have a cut barrel or something super rare - cubrock, 2014-07-24, 16:32
- You may want to measure that barrel again -
Fivegunner,
2014-07-24, 16:21
- Perhaps it is a 3.5"??? (Picture included) -
Murphy,
2014-07-25, 00:00
- Perhaps it is a 3.5"??? (Picture included) -
Catoosa,
2014-07-25, 09:29
- Perhaps it is a 3.5"??? (Picture included) - Fivegunner, 2014-07-26, 06:52
- Perhaps it is a 3.5"??? (Picture included) -
Catoosa,
2014-07-25, 09:29