You may want to measure that barrel again
It shouldn't be 4" from that vintage. Might be a factory 3.5" or 5" or something cut down. Or, it could have been rebarreled with a factory 4" barrel, which they introduced in the last couple or three years of -2 production (very late 70s to very early 80s). It should have a serial number in the ejector rod cutout that should match the serial number on the butt.
It could be a $300 gun or a $1500 gun. All depends on configuration and condition.
Complete thread:
- S&W pre 27??? -
Fivegunner,
2014-07-23, 15:51
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- S&W pre 27??? - Wildcat, 2014-07-23, 17:49
- Approximately 1954 (NM). - Murphy, 2014-07-23, 18:09
- You may want to measure that barrel again -
cubrock,
2014-07-23, 20:52
- You may want to measure that barrel again -
Fivegunner,
2014-07-24, 16:21
- You either have a cut barrel or something super rare - cubrock, 2014-07-24, 16:32
- You may want to measure that barrel again -
Fivegunner,
2014-07-24, 16:21
- Perhaps it is a 3.5"??? (Picture included) -
Murphy,
2014-07-25, 00:00
- Perhaps it is a 3.5"??? (Picture included) -
Catoosa,
2014-07-25, 09:29
- Perhaps it is a 3.5"??? (Picture included) - Fivegunner, 2014-07-26, 06:52
- Perhaps it is a 3.5"??? (Picture included) -
Catoosa,
2014-07-25, 09:29