How to trim hundreds of 243 or .308 to 1.2"?
A lot of guys cutting .223 brass down to .300 blackout length are rough cutting them with a cheap little Harbor Freight chop saw. Several guys are making aluminum jigs to hold them to the proper length. Final trimming is done after rough cutting. You could just clamp them in the vise or make a simple jig like this one
Complete thread:
- How to trim hundreds of 243 or .308 to 1.2"? -
Mike P,
2014-07-15, 07:17
- How to trim hundreds of 243 or .308 to 1.2"? - Paul, 2014-07-15, 08:42
- How to trim hundreds of 243 or .308 to 1.2"? -
Rgates,
2014-07-15, 09:14
- How to trim hundreds of 243 or .308 to 1.2"? -
Mike P,
2014-07-15, 11:17
- How to trim hundreds of 243 or .308 to 1.2"? - uncowboy, 2014-07-15, 11:23
- How to trim hundreds of 243 or .308 to 1.2"? -
Mike P,
2014-07-15, 11:17
- How to trim hundreds of 243 or .308 to 1.2"? - Slow Hand, 2014-07-15, 12:01
- Depending on quantity, either a 5C collet with a collet stop - John K., 2014-07-15, 14:47