Good eyes!
Yes, the HP spud is in fact newer than the rest of the mould. A previous owner of this mould had ground the HP pin down so that it made a FP bullet, so I had to make a replacement spud to make HPs once again.
Complete thread:
- Paging fatboy! How are your experiments.... -
Glen,
2013-08-28, 12:04
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Paging fatboy! How are your experiments.... -
bob,
2013-08-28, 18:09
- 3031 should be just fine. (nm) -
Glen,
2013-08-28, 18:46
- to answer your question -
bob,
2013-08-28, 21:52
- Length = .860" (nm) -
Glen,
2013-08-28, 23:01
- Length = .860" (nm) - bob, 2013-08-29, 00:22
- Length = .860" (nm) -
Glen,
2013-08-28, 23:01
- to answer your question -
bob,
2013-08-28, 21:52
- 3031 should be just fine. (nm) -
Glen,
2013-08-28, 18:46
- Paging fatboy! How are your experiments.... -
Slow Hand,
2013-08-28, 18:55
- New? Not hardly! -
Glen,
2013-08-28, 20:04
- New? Not hardly! -
Slow Hand,
2013-08-29, 04:50
- Good eyes! - Glen, 2013-08-29, 08:40
- New? Not hardly! -
Slow Hand,
2013-08-29, 04:50
- New? Not hardly! -
Glen,
2013-08-28, 20:04
- Paging fatboy! How are your experiments.... -
bob,
2013-08-28, 18:09