New? Not hardly!
This is a Yankee bullet mould that dates back to the 1930s or 1940s. I suspect that it would feed OK in your AR, but I don't know how well it would shoot in the fast twist barrel (cast bullets tend to do better with slower twist rates). The faster twist can be dealt with by reducing velocity down to ~1500 fps, and a cast HP will still expand very well at these speeds, but I seriously doubt that it would cycle the action on your AR at these speeds.
Complete thread:
- Paging fatboy! How are your experiments.... -
Glen,
2013-08-28, 12:04
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Paging fatboy! How are your experiments.... -
bob,
2013-08-28, 18:09
- 3031 should be just fine. (nm) -
Glen,
2013-08-28, 18:46
- to answer your question -
bob,
2013-08-28, 21:52
- Length = .860" (nm) -
Glen,
2013-08-28, 23:01
- Length = .860" (nm) - bob, 2013-08-29, 00:22
- Length = .860" (nm) -
Glen,
2013-08-28, 23:01
- to answer your question -
bob,
2013-08-28, 21:52
- 3031 should be just fine. (nm) -
Glen,
2013-08-28, 18:46
- Paging fatboy! How are your experiments.... -
Slow Hand,
2013-08-28, 18:55
- New? Not hardly! -
Glen,
2013-08-28, 20:04
- New? Not hardly! -
Slow Hand,
2013-08-29, 04:50
- Good eyes! - Glen, 2013-08-29, 08:40
- New? Not hardly! -
Slow Hand,
2013-08-29, 04:50
- New? Not hardly! -
Glen,
2013-08-28, 20:04
- Paging fatboy! How are your experiments.... -
bob,
2013-08-28, 18:09