OEM pin is
I only have a 6" dial daliper, but it's a pretty good one.
It says 0.248 so perhaps a BM pin would help.
Thank you for your reply. 
--
![[image]](http://www.sixshootercommunity.com/share/awkward.gif)
Complete thread:
- Ruger OMSBH Question -
FOG,
2013-01-05, 11:21
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Cylinder should rotate freely -
Bj2,
2013-01-05, 11:40
- RE: Cylinder should rotate freely -
FOG,
2013-01-05, 13:15
- Belt Mountain pins are -
Paul,
2013-01-05, 15:35
- OEM pin is -
FOG,
2013-01-05, 16:04
- It's necessary to remove . . . -
Kentucky,
2013-01-05, 16:21
- It's necessary to remove . . . -
Dennis Eugene,
2013-01-05, 17:12
- re: KY's advice - FOG, 2013-01-05, 17:30
- It's necessary to remove . . . -
Dennis Eugene,
2013-01-05, 17:12
- It's necessary to remove . . . -
Kentucky,
2013-01-05, 16:21
- OEM pin is -
FOG,
2013-01-05, 16:04
- RE: Cylinder should rotate freely -
bj,
2013-01-05, 19:43
- RE: Cylinder should rotate freely -
Paul,
2013-01-05, 20:55
- RE: Cylinder should rotate freely - bj, 2013-01-05, 21:10
- RE: Cylinder should rotate freely - FOG, 2013-01-06, 09:43
- RE: Cylinder should rotate freely -
Paul,
2013-01-05, 20:55
- Belt Mountain pins are -
Paul,
2013-01-05, 15:35
- RE: Cylinder should rotate freely -
FOG,
2013-01-05, 13:15
- Cylinder should rotate freely -
Bj2,
2013-01-05, 11:40