JB and heat
I have found most epoxies will either break down, soften or begin to fail about +400 Degress F. There are some high temp. epoxies, might be able to research both J.B. and what else is out there. Good Luck on your effors. As mentioned make certain nothing is obstructing the bore from the flash hider. Good Luck.
Complete thread:
- JB and heat -
Catoosa,
2012-10-11, 09:38
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- I've seen this happen before on a mini - the entire assembly -
John K.,
2012-10-11, 11:06
- lose the glue - mike c, 2012-10-12, 16:07
- JB and heat - Alfred John, 2012-10-11, 12:10
- I know of someone ..ahem.. who used JB weld and a nickel - stonewalrus, 2012-10-11, 12:24
- I'd try Loctite 620 High Temp Bearing Mount -
JD,
2012-10-11, 14:40
- and jb weld has ahigh heat version also: - cable, 2012-10-11, 16:37
- JB and heat -
John Meeker,
2012-10-11, 20:16
- I used Loctite 680 - Mark Stevenson, 2012-10-11, 23:35
- Thanks, Y'all! - Catoosa, 2012-10-12, 16:58
- I've seen this happen before on a mini - the entire assembly -
John K.,
2012-10-11, 11:06