A simple little project for casters...

by Slow Hand , Indiana, Saturday, September 22, 2012, 15:58 (4447 days ago)

I had this idea awhile back and finally took care of it. I took a short section of 4x4, about 8" and cut in half on a 45. I just used my heap circular saw. Then I drilled some holes in it, a little over 1/4" and some 3/4" ones. The row of smaller holes is for top punches and te bigger holes are for the sizing dies. I've been casting for about ten years and only have a few sizing dies but at least thy are now stored better and easily accessible. Plus, I've got plenty of room to expand!!