Rossi .357 Carbine question
I had the same problem some years ago with a .22 rifle. I took the rear sight off and used a pointed burr in a Dremel tool to cut the notch out deeper and make it round with the top open, sort of like a 3/4 aperture. Centering the bead in the opening put the POI right where I wanted and was very quick.
Complete thread:
- Rossi .357 Carbine question -
AaronB,
2011-12-05, 11:18
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Rossi .357 Carbine question - Catoosa, 2011-12-05, 11:36
- 50yd -0- yields 2.58" low @ 100 -
Hoot,
2011-12-05, 12:03
- 2" high at 50yds equals a 125yd zero. 2.4" high at 70yds -
RangerBob,
2011-12-05, 12:16
- 2" high at 50yds equals a 125yd zero. 2.4" high at 70yds -
AaronB,
2011-12-05, 12:35
- Ran the numbers again with the "Point Blank" software - RangerBob, 2011-12-06, 06:47
- 2" high at 50yds equals a 125yd zero. 2.4" high at 70yds -
AaronB,
2011-12-05, 12:35
- 2" high at 50yds equals a 125yd zero. 2.4" high at 70yds -
RangerBob,
2011-12-05, 12:16
- Rossi .357 Carbine question -
WIL TERRY,
2011-12-05, 14:23
- 1:30 twist . . . recoil for an 11 year old. - RangerBob, 2011-12-05, 14:26
- "The velocity should be WELL above the figures you note." -
AaronB,
2011-12-05, 14:43
- "The velocity should be WELL above the figures you note." - WIL TERRY, 2011-12-05, 15:11
- I concur... -
Hobie,
2011-12-05, 21:14
- Multiple other issues are in play here. -
AaronB,
2011-12-06, 09:40
- Multiple other issues are in play here. - stonewalrus, 2011-12-06, 11:41
- Multiple other issues are in play here. -
AaronB,
2011-12-06, 09:40
- Rossi .357 Carbine question - Warhawk, 2011-12-19, 22:38