Remington Model 81, 300 Savage.

by Slow Hand , Indiana, Sunday, September 24, 2023, 16:00 (425 days ago) @ A K Church

Not 100% familiar with the .300, but I know the .35’s use a special and very expensive stripper. I bought some 3d printed ones that in practice seem to work well. I haven’t had them out to the range yet, but loading it at home is basically the same as loading it at the range or in the field.

https://cogburnarsenal.com/product/remington-model-8-81-stripper-clips/

I never tried it but I would bet if you put a couple of bumps near the middle of each ‘skinny’ side to keep it from pushing down into the mag well, most any Mauser or USGI stripper would work.

--
https://facebook.com/M2bKydex/