Ruger Old Army mainspring question
by Paul 
, Saturday, January 16, 2021, 18:57 (1407 days ago)
A while back I picked up a Ruger Old Army to replace the one I sent down the road years before. It's got a lovely, light action - but does not reliably set off the caps, unlike my first ROA with which I never had a failure to fire due to cap issues.
My understanding is that the Ruger Old Army uses the same mainspring as the Blackhawk and Vaquero. Is this correct? Where would someone find such a spring in today's market? Jack First has ROA springs, at $12 a pop... that seems a bit salty to me - but haven't had occasion to shop springs in quite a while. Brownells is sold out of Blackhawk mainsprings. Not sure where else to look.
Same size, different strength.
I believe they're a few pounds heavier than the Blackhawk spring.
Wolff springs sells them for about 4 1/2 bucks.
Under single action springs they show...
"Factory Standard..: 23 Lb. (Reference Only)
Extra Power.........: 24, 25, 26 and 28 Lb."
Same size, different strength. Old Army 27#
by Mike P 
, Monday, February 01, 2021, 19:30 (1391 days ago) @ cas
If I recall correctly Ruger Old Army springs average about 27#. Some longer range shooters with good trigger work used to swap them into Blackhawks to slightly reduce lock time.
--
AKA zzr7ky
have you checked your spring?
by bj , Sunday, January 17, 2021, 19:20 (1406 days ago) @ Paul
I wonder if the spring can be seated in the wrong place. Also the stock configuration would allow you to shim the spring with washers or something similar to increase the force on the hammer.