Hey JohnK.....

by Gunner , St Louis, Monday, March 11, 2019, 20:31 (2084 days ago) @ John K.

Yes using the mill, actually don't own a drill press since I got the mill. I am using two step type bits to cut the screw holes, one a industrial type two stage, while I like it better, though the shoulder cutter has a slight radius edge on it. The other cutter is one made specially for this job, spade blade type, it cuts a nicer shoulder but is harder to use and have clean cuts in the scales.

It is kinda funny, I focused so much on using the end mills to do the notching it didn't dawn on me to use a end mill to do the screw holes : (

Have to pick up a couple end mills, do some math and try it that way. Any preferred brands of end mills and a good source to buy them?????? I follow Helical and Harvey Tools on Instagram, they are really nice but seem on the high end, not sure I need that pricey of a end mill for what I am doing.

Thoughts and recommendations are welcome,

Gunner

--
https://www.instagram.com/41gunner/
41 Mags rule, Baers rock!