ANYONE HERE CAST 338 AND 375?

I would like to try some lead reloads in my 338 and 375 but don't want to jump in with both feet yet.

--
Of the Troops & For the Troops

988 views

you looking to borrow molds or just get some bullets? Hunting bullets I asume? J.Michael

984 views

Bummer! I sold my 338 a few years back, and just melted my remaining 250 LBTs to recycle them into .357s. I may know where there's a "Walt" era 300 gr 375 mould available if you get to that point. I will double-check to make sure I don't have more 338s lurking about.

Post reply

951 views

--
Of the Troops & For the Troops

Post reply

990 views

What ya gonna shoot em out of.

Lee C338-220 is an accurate bullet out of a model 70 338 Mag with 39 grains of 3031 as is the Hornady 200 grain FP they used to sell for 33 Winchester. Same size group and POI at 50 yards, I never worry about shooting further away here in Middle TN with that rifle except to plink.

Too bad the Lee is not a FP.

I will look I think I have some cast from the RCBS 200 grainer FPGC, and I just got a Ranch Dog mold for FPPB 200 grainers I need to cast up. I thinking my sizing die is 0.339".

Let me see what I have lying around gathering dust.

Louis

Post reply

988 views

I guess I'm completely out of the 338 business at this point. I was just a bit big for prairie dogs.

Post reply

941 views

RSS Feed of thread

The Frontier Sixshooter Community Message Board

ANYONE HERE CAST 338 AND 375?

ANYONE HERE CAST 338 AND 375?

I'm looking to buy some bullets

I'm looking to buy some bullets

I did melt my leftovers down,