Been googling - don't think I have the trigger spring right
If it will stay cocked without the cylinder , and won't when you install the cylinder the bottom foot on the pawl is too long. You need to file it down until the timing is right.
It sounds like the hammer travel is stopped because the pawl is still trying to turn the cylinder and the bolt is engaged.
Complete thread:
- Ruger Bisley Conversion - remind me next time I am not a -
stonewalrus,
2016-07-20, 16:20
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Ruger Bisley Conversion - remind me next time I am not a -
Bob Hatfield,
2016-07-20, 16:39
- tried that. No luck. First time I assembled it, hammer and -
stonewalrus,
2016-07-20, 17:14
- Check the pawl. -
Caz,
2016-07-20, 17:26
- Check the pawl. -
uncowboy,
2016-07-20, 17:58
- Tried that - still same problem. I have it according to the - stonewalrus, 2016-07-20, 20:13
- That appears to be ok -
stonewalrus,
2016-07-20, 20:15
- That appears to be ok -
Fowler,
2016-07-20, 20:38
- Been googling - don't think I have the trigger spring right -
stonewalrus,
2016-07-20, 20:53
- Been googling - don't think I have the trigger spring right -
Jared,
2016-07-20, 23:06
- That is what I meant...check the pawl. -
Caz,
2016-07-20, 23:30
- That is what I meant...check the pawl. -
Jared,
2016-07-20, 23:42
- And I appreciate that! Thanks! - Caz, 2016-07-21, 10:36
- That is what I meant...check the pawl. -
Jared,
2016-07-20, 23:42
- Now it won't stay cocked with or without the cylinder -
stonewalrus,
2016-07-21, 18:00
- I wish you were closer Tom. -
Hoot,
2016-07-22, 08:55
- With my "expertise" I should never have taken apart - stonewalrus, 2016-07-22, 19:29
- I wish you were closer Tom. -
Hoot,
2016-07-22, 08:55
- That is what I meant...check the pawl. -
Caz,
2016-07-20, 23:30
- Been googling - don't think I have the trigger spring right -
Jared,
2016-07-20, 23:06
- Been googling - don't think I have the trigger spring right -
stonewalrus,
2016-07-20, 20:53
- That appears to be ok -
Fowler,
2016-07-20, 20:38
- Check the pawl. -
uncowboy,
2016-07-20, 17:58
- Check the pawl. -
Caz,
2016-07-20, 17:26
- tried that. No luck. First time I assembled it, hammer and -
stonewalrus,
2016-07-20, 17:14
- That loading gate has to be installed correctly as well. - Hobie, 2016-07-20, 21:53
- Ruger Bisley Conversion - remind me next time I am not a -
Bob Hatfield,
2016-07-20, 16:39