Colt 1917 request.
by Hoot 
, Diversityville, Liberal-sota, Thursday, December 24, 2015, 15:32 (3196 days ago)
Can someone with a Colt 1917 please measure the thickness of the ejector "arms" for me? I am trying to figure out if the ejector star is the same for .45 ACP, .45 Colt and .455 Eley. Numrich lists only a single part number but I'd like to be more sure.
No rush at all. This is a back shelf project.
Thank you!
Hoot
Colt 1917 request.
by rob , Thursday, December 24, 2015, 20:57 (3196 days ago) @ Hoot
I'll try and measure mine too. Might be tomorrow evening but I can do it.
Colt 1917 request.
I measured mine. They are about .080" thick +- near the ratchet, and they taper to about .070" at the tip of the star.
Thank you Jared!
by Hoot , Diversityville, Liberal-sota, Friday, December 25, 2015, 08:36 (3195 days ago) @ Jared
My New Service was originally a .455 Eley which had been 'shaved'. I sourced an untouched .455 cylinder with ejector and rod. However, the ejector star does not screw down tightly, as if the threads are stripped. Fella on GB has an ejector for a 1917 and I was hoping they were the same beastie. Mine measures just as yours does.
Thanks again!
Thank you Jared!
Glad I could help, and that they are the same. That will make life much easier. Merry Christmas
Merry Christmas to you and Kathryn as well.
by Hoot , Diversityville, Liberal-sota, Friday, December 25, 2015, 22:53 (3195 days ago) @ Jared
***
Thank you Jared!
by rob , Saturday, December 26, 2015, 10:26 (3194 days ago) @ Hoot
Sounds like you got it figured out. If you want me to go ahead and measure mine, let me know and I'd be glad to.
Thank you Rob.
by Hoot , Diversityville, Liberal-sota, Saturday, December 26, 2015, 10:38 (3194 days ago) @ rob
If it's no trouble, yes please. That would give me 4 data points: yours, Jared's, mine and Numrich's single part number. A feller could be pretty certain with that! 
Then it comes to fitting it all up. I have brass and proper hollow base bullets. It ought to be some kind of fun!