if not flexed or stressed, rivet holes fine.
Will break at holes otherwise....thin stuff just preheat and dip in melted solder pot for tinning, then clamp and heat...torch probably better than iron...
Complete thread:
- A question for the metal smiths -
bob,
2015-06-16, 10:00
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Spring steel is normal carbon steel, normally.... -
passing by,
2015-06-16, 19:34
- Spring steel is normal carbon steel, normally.... -
bob,
2015-06-17, 08:58
- you probably already know about tinning/coating -
passing by,
2015-06-17, 13:06
- you probably already know about tinning/coating -
bob,
2015-06-17, 22:47
- if not flexed or stressed, rivet holes fine. -
passing by,
2015-06-19, 10:44
- if not flexed or stressed, rivet holes fine. - bob, 2015-06-20, 12:26
- if not flexed or stressed, rivet holes fine. -
passing by,
2015-06-19, 10:44
- you probably already know about tinning/coating -
bob,
2015-06-17, 22:47
- you probably already know about tinning/coating -
passing by,
2015-06-17, 13:06
- Spring steel is normal carbon steel, normally.... -
bob,
2015-06-17, 08:58
- when I was working in my dad's shop -
bj,
2015-06-18, 19:37
- we always brush on flux, core stuff never seems enough...NT - passing by, 2015-06-19, 10:47
- Spring steel is normal carbon steel, normally.... -
passing by,
2015-06-16, 19:34