Thinning out the herd, Part III

by Scribe, Sunday, December 07, 2014, 12:30 (3644 days ago)

I took my guns down to my FFL yesterday to drop them off with him so the guns could be shipped upon receipt of funds. I was advised NOT to do it this way because of NJ law. If I sign them over and the buyer(s) backs out at the last minute, the guns are still listed as belonging to the store. To get them back, I would have to APPLY FOR PERMITS to retrieve my own guns!

I was advised to keep them until receipt of funds, then to drop them off at the FFL for legal shipment to the buyer's FFL. So that's what I am doing. I am listing the four items that seemed to generate the most comments/interest.

To recap from an earlier post, my FFL, Bob's Little Sport Shop in Glassboro, NJ, is charging $90 for the FFL fee plus shipping cost per handgun. I will add that to each gun's price:

1) Ruger .45 LC Old Model Blackhawk revolver, blue, 7 1/2 in. barrel. Unconverted. VG condition. Previous owner had first initial and last name plus 12-25-74 inscribed just below barrel address. Hard to make out, but it's there. Non-original grips (he had carved the faux ivory grips that came with the gun, so I replaced them.) Some muzzle wear and scratches on ejector rod. No box, no papers.

ASKING $800, plus $90 FFL fee/shipping

2)Ruger .45 LC/.45 ACP Old Model Blackhawk revolver, blue, 7 1/2 in. barrel. Uncoverted. Very good condition. Spare .45 ACP cylinder. .45 LC cylinder has been reblued. Hammer has been blued. Grip frame is gray because aluminum blacking was ground off, not polished. Some muzzle wear. No box, no papers.

ASKING $900, plus $90 FFL fee/shipping

3)S&W pre-27 .357 Magnum revolver. S-frame. 3 1/2 in. non-original barrel. Very good condition. Minor wear on edge of cylinder. White Out on front sight. Walnut grips. Coolest looking DA revolver ever made. No box or papers.

(The orginal 8 3/8 in. barrel is available separately but has a slim bulge about 2 inches from muzzle due to a squib load that lost its copper plating. Candidate to make a 5 in. barrel? Would run about $100, plus shipping, if desired.)

ASKING $2,000, plus $90 FFL fee/shipping

4) S&W .45 ACP 1937 Brazilan Contract Model Revolver. The 1937 marque on right hand side of frame is worn. Carries numbers (faint) on backstrap of grip 3153 that are not related to serial number. Reblued. Lanyard loop and humpback hammer. Did not have original wooden grips when purchased, so now wears Fitz StaGrip grips, plus black Tyler-T Grip instead.

ASKING $400, plus $90 FFL fee/shipping

If interested, email me at flaquito@aol.com. I have some cell phone pics; send me your cell phone number if you'd would like me to send them.

Two guys have had their hands up for these for a while, so first offers would be accepted from them, unless they pass.

Scribe