I don't know
It is a 5" barrel so it would be pretty short if I cut it. Plus there is no real forcing cone. The guy I got it from had the work done in the early 70s no telling what the barrel was off of.
Complete thread:
- Curious result from dumb gun smithing mistake -
stonewalrus,
2014-06-04, 12:06
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Curious result from dumb gun smithing mistake -
Lee J.,
2014-06-04, 14:54
- Curious result from dumb gun smithing mistake -
uncowboy,
2014-06-04, 15:00
- Curious result from dumb gun smithing mistake -
Jared,
2014-06-04, 18:08
- I wonder what would happen... -
Slow Hand,
2014-06-05, 04:58
- I don't know - Jared, 2014-06-05, 09:29
- I wonder what would happen... -
Slow Hand,
2014-06-05, 04:58
- Curious result from dumb gun smithing mistake -
Jared,
2014-06-04, 18:08
- Yup - having the correct tools is a major factor - stonewalrus, 2014-06-04, 15:21
- Curious result from dumb gun smithing mistake -
uncowboy,
2014-06-04, 15:00
- My guess is that your replacement barrel... -
Sarge,
2014-06-04, 18:34
- I took a closer look at the old barrel - Taurus did a sloppy - stonewalrus, 2014-06-04, 19:04
- Curious result from dumb gun smithing mistake -
Lee J.,
2014-06-04, 14:54