Anything else I need to order from that knife place...
by Gunner 
, St Louis, Sunday, April 20, 2014, 18:12 (3876 days ago) @ pokynojoe
Two part epoxy, Devcon or Gorilla, 5 minute set or slower and highest psi you can get. Use 120 or 150 grit sandpaper on the tang and back side of the handle scales, no deep groves just slightly scuff up the surface, better contact point for the epoxy to bond to. Some kind of material to make pin/s with, I have used brass, aluminum, steel and even clothes hanger wire.
Something like this might solve the pin issue with your tang...
http://www.knifemaking.com/SearchResults.asp?Search=as971
--
https://www.instagram.com/41gunner/
41 Mags rule, Baers rock!
Complete thread:
- Epoxy work Saturday........ -
Gunner,
2014-04-20, 10:44
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- I like that one. - Hoot, 2014-04-20, 10:55
- Boy, do I need your help!... -
pokynojoe,
2014-04-20, 11:05
- Boy, do I need your help!... - Slow Hand, 2014-04-20, 12:32
- Suggestions....... -
Gunner,
2014-04-20, 15:12
- Hey THANKS!... -
pokynojoe,
2014-04-20, 15:34
- Suggestions 2.... - Gunner, 2014-04-20, 18:02
- Anything else I need to order from that knife place... -
pokynojoe,
2014-04-20, 17:47
- Anything else I need to order from that knife place... -
Gunner,
2014-04-20, 18:12
- Thanks, I'll see about order all this stuff tomorrow... - pokynojoe, 2014-04-20, 18:18
- Anything else I need to order from that knife place... -
Gunner,
2014-04-20, 18:12
- Hey THANKS!... -
pokynojoe,
2014-04-20, 15:34
- Boy, do I need your help!... - Catoosa, 2014-04-20, 21:56
- I have that same blade - bj2, 2014-04-20, 23:27
- I have that same knife with Micarta handles. Gunner - TomC, 2014-04-20, 17:56
- I ordered all the stuff this morning... - pokynojoe, 2014-04-21, 10:21