I have several vices -
but at my age, they are getting harder to maintain. LOL, sorry guys, I couldn't help it.
Rob, you can take the slide off, lay it on one side on a flat surface and measure from the flat surface... flip over to the other side and repeat. You can tell close enough with just a Starret scale. Of course, there's still the issue of the barrel-to-slide tolerances causing wonky sight settings.
A double dovetail setup will let you split the diff left & right, front and rear if there is something weird with the barrel fitting. Not quite so noticeable that way.
Complete thread:
- Finally determined my Colt 1911 front sight is indeed... -
rob,
2014-04-07, 22:54
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- In my experience.... -
Glen,
2014-04-07, 23:14
- I have a vice but no brass plates or other suitable... -
rob,
2014-04-07, 23:31
- I have several vices - -
John K.,
2014-04-08, 00:05
- I have several vices - - rob, 2014-04-08, 00:14
- I have several vices - -
John K.,
2014-04-08, 00:05
- Cutting dovetails in a Colt Military slide -
RidinLou,
2014-04-08, 20:56
- Go to the Brownell's website.... - Glen, 2014-04-09, 00:53
- I have a vice but no brass plates or other suitable... -
rob,
2014-04-07, 23:31
- Like Glen said, Dovetail the front sight -
Miles Fortis,
2014-04-08, 09:52
- I had my commander dove tailed at Advanced Gun Works - MR, 2014-04-08, 10:45
- Rob, did I stupid out (again)? -
Hoot,
2014-04-08, 23:02
- Only if it was one of the first two or three CSA's ... -
rob,
2014-04-09, 00:16
- OK, good. I am trying harder to remember names and faces. - Hoot, 2014-04-09, 05:59
- Only if it was one of the first two or three CSA's ... -
rob,
2014-04-09, 00:16
- In my experience.... -
Glen,
2014-04-07, 23:14