Odd reloading die question
by Hoot 
, Diversityville, Liberal-sota, Saturday, February 11, 2012, 11:20 (4669 days ago)
I'd like to figure out if my 7mm Rem Mag dies have enough room for a 3/8" long neck. What would you suggest to figure this out? I was thinking of making a CerroSafe casting might be the best way to go. Other ideas?
Thanks!
Trade it for a 30-06... Just sayin...
by Rob Leahy 
, Prescott, Arizona, Saturday, February 11, 2012, 13:43 (4669 days ago) @ Hoot
Carosafe is the way to go.
--
Of the Troops & For the Troops
Borrrrr-innnng!
by Hoot , Diversityville, Liberal-sota, Sunday, February 12, 2012, 10:39 (4668 days ago) @ Rob Leahy
hahaha I already have a few '06's and keep looking to change them into something else. I'll likely keep the FN Mauser as an '06 but the 1917 may become an 8mm Mag or mebee a 9.3x62....depends on what the No. 1 '06 becomes--35 Winchester anyone? 
Yeah, I'll be melting up some CerroSafe for a chamber cast. May as well cast the die too. I tried runing a .300H&H case in the 7mm die but the shoulder collapsed and it wasn't clear to me just how much neck room I had.
Thanks Rob!
I would try probing with a piece of wire
by bj , Monday, February 13, 2012, 11:07 (4667 days ago) @ Hoot
The part that sizes the neck should be a straight cylinder and you could feel if it changed diameter or ended.
Thanks bj!
by Hoot , Diversityville, Liberal-sota, Monday, February 13, 2012, 14:14 (4667 days ago) @ bj
I did give that a try but results were inconclusive...