Just use a std taper crimp die.
Crimp the cartridge until the case mouth is just slightly pressed into the bullet wall, then check a few for chambering & function. A taper crimp die only prevents the bullet from being pushed into the case while chambering anyway.
Complete thread:
- I pulled a couple of those 9mm cast 124's -
Slow Hand,
2013-09-20, 20:12
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Just use a std taper crimp die. -
anachronism,
2013-09-20, 20:51
- I just use a taper crimp die too. - Jared, 2013-09-20, 20:57
- I stopped using the FCD on straight wall stuff... -
rob,
2013-09-20, 23:17
- The factory crimp die in handguns is designed to -
Todd C,
2013-09-21, 08:25
- I did this too. - anachronism, 2013-09-21, 09:01
- Just looked at my ACP die.... -
rob,
2013-09-21, 09:46
- Just looked at my ACP die.... - Jared, 2013-09-21, 12:46
- How did you get the ring out? -
rob,
2013-09-21, 09:50
- How did you get the ring out? -
anachronism,
2013-09-22, 09:05
- That sounds good... - rob, 2013-09-22, 17:13
- How did you get the ring out? -
anachronism,
2013-09-22, 09:05
- The factory crimp die in handguns is designed to -
Todd C,
2013-09-21, 08:25
- I pulled a couple of those 9mm cast 124's - Cherokee, 2013-09-21, 14:54
- Just use a std taper crimp die. -
anachronism,
2013-09-20, 20:51