The M24-3 cylinder was recalled, within a specific serial

by brionic , Sunday, July 28, 2013, 08:08 (4141 days ago) @ FOG

number range, due to bad heat treating.

Factory sponsored inspections resulted in either stamped boxes for "passed" guns or replaced cylinders on "bad" guns, which is what you undoubtedly saw.

Exhaustion of new replacement cylinders and other parts has altered the factory repair paradigm. Look before you leap.

Post reply

755 views

Complete thread:

RSS Feed of thread

S&W "Heritage" hand ejectors - brionic, 2013-07-27, 23:04
- Yes, the N-frames have the 'endurance package' - FOG, 2013-07-28, 00:09
  - The M24-3 cylinder was recalled, within a specific serial - brionic, 2013-07-28, 08:08
    - The M24-3 cylinder was recalled, within a specific serial - SteveA, 2013-07-28, 10:07
      - Think you might be right Steve... - pokynojoe, 2013-07-28, 13:21
      - Right, I'm confused (again) - brionic, 2013-07-28, 17:37
- I have a couple of those, great sixguns. (nm) - Boge Quinn, 2013-07-28, 16:18
  - Thx. I bought it. - brionic, 2013-07-28, 17:41
    - Well done! A Boge-style deal, according to Jeff means... - Boge Quinn, 2013-07-28, 18:06
      - Ha! I did both, dumbfounded by my luck. - brionic, 2013-07-28, 18:40
        
        Looking forward to it! I have... - Boge Quinn, 2013-07-29, 14:48
        
        I remember when you bought your .44 - brionic, 2013-07-29, 16:03
        
        And a hint: - brionic, 2013-07-29, 16:06
        
        Beautiful! The bluing on those... - Boge Quinn, 2013-07-29, 16:50
        
        Pssssst... - FOG, 2013-07-29, 18:04
        
        'They usually show up in threes' - FOG, 2013-07-29, 18:17
        
        That's a dandy. - Hoot, 2013-07-31, 14:47
    - Probably no need to worry about the cyl throats on that one - FOG, 2013-07-29, 18:27

The Frontier Sixshooter Community Message Board

The M24-3 cylinder was recalled, within a specific serial