Price Check on a Winchester Model 71
by Remington40x 
, SE PA, Friday, May 31, 2013, 10:06 (4198 days ago)
One of my local purveyors of temptation has a Winchester Model 71 rifle for sale. The metalwork is immaculate, with only the slightest bluing wear on the edges, except that the rear sight has been removed, the slot filled and a Lyman peep sight installed. So far, so good. Now the bad part:
The wood would be in like condition, had someone not carved a cougar sitting on a rock on the right side of the buttstock, shortened the butt and installed a white line recoil pad. While I can appreciate the pad on a .348 (which I'd replace with something more appropriate looking), the cougar is just not a value enhancer.
The asking price is $795, which would be a screaming buy, absent the problems with the buttstock. What are your thoughts on the value as described?
Thanks.
I'd be all over that.
by Hoot , Diversityville, Liberal-sota, Friday, May 31, 2013, 10:12 (4198 days ago) @ Remington40x
I never see them for less than $1200 and I'd figure a fella could buy a butt stock for less than the $400 difference.
I'd buy... Unless the carving job is gawd awful.
Then I'd try and wiggle downward.
Wanna tell me where it is? I'll go check it out for you.
Wanna tell me where it is? I'll go check it out for you.
by John Meeker , Friday, May 31, 2013, 12:31 (4198 days ago) @ cas
Send me the buttstock..I'll pack the carving with wood-dough epoxy, fair it out, and color it in.Or, youcan do that, too, Or, put a fancy veneer over the epoxy so it so it has 'splint personality' ;~`). Or splice in a piece of old walnut from a beater stock. The butt-cuff is good idea...Truly, that's a nice raffle-gun. I'd bet a replacement stock or Numrich take-off isn't all that much. There's a guy out in MidWest who makes lots of Marling stocks, too. Your blank, or his.
Just feeling optimistic today, and playing late lunch hooky at the computer, so don't get too cheered up by me. ;~`)
poorly carved stocks...I have seen a pile of em...
by Rob Leahy 
, Prescott, Arizona, Friday, May 31, 2013, 10:27 (4198 days ago) @ Remington40x
edited by Rob Leahy, Friday, May 31, 2013, 10:31
mostly farther north, where long winters in isolation and alcohol fuel this form of "artistry." A Cartridge cuff should cover the carving, if you can't find a new stock.
Rob
--
Of the Troops & For the Troops
Here you go...
by Paul , Friday, May 31, 2013, 15:19 (4198 days ago) @ Remington40x
Oh, NO! that is some nice wood. I love the Ballard pistol
by Rob Leahy , Prescott, Arizona, Friday, May 31, 2013, 15:49 (4198 days ago) @ Paul
grip on old Marlins... I have a 1949 vintage 336 24" half mag 30-30 that would look fantastic http://www.treebonecarving.com/id9.html
--
Of the Troops & For the Troops